Tree trimming is dangerous work: in BLS's 2024 Census of Fatal Occupational Injuries chart, grounds maintenance workers (the group tree trimmers are counted in) recorded 20.9 fatal work injuries per 100,000 full-time-equivalent workers, against an all-worker rate of 3.3.
The Tree Care Industry Association counted 243 tree-care deaths from 2020 through 2023.
Struck-by incidents, falls and electrical contact lead the causes.
Fatality rate compared with other jobs
BLS's Occupational Outlook Handbook draws the contrast carefully: fatalities are uncommon in grounds maintenance, yet grounds maintenance workers experience one of the highest fatality rates of all occupations.
Tree trimmers and pruners are counted inside that group.
In the most recent Census of Fatal Occupational Injuries chart of selected occupations (2024 data), grounds maintenance workers recorded 239 deaths and a fatal work-injury rate of 20.9 per 100,000 full-time-equivalent workers.
The all-worker rate in the same chart was 3.3.
For scale, the chart's highest rate belongs to logging workers, at 110.4.
Logging is a separate occupation in BLS's data, so that figure describes the chart's range, not tree trimming.
One scope note matters when you compare figures.
BLS's chart prints rates for the whole grounds maintenance group, not a tree-trimmer-only rate; the specific count for tree trimmers and pruners sits in the full CFOI tables, which our research could not retrieve.
Any single rate you see attached to tree trimming alone is not from this chart.
The number is also a rate, not a tally: it is normalized per full-time-equivalent worker.
That is how a group BLS describes as seeing uncommon fatalities can still carry one of the highest fatality rates of all occupations.
The practical reading for a climber is that both OSHA's and TCIA's lists point to a short set of named causes, covered next.
Top causes of deaths and injuries
OSHA lists the common tree-care hazards as falls from trees, being struck by falling trees or branches, injury or death during chainsaw or woodchipper operation, and contact with energized power lines.
The Tree Care Industry Association keeps its own count of fatal accidents, which it gathers by gleaning news media and OSHA fatality reports.
Its total for 2020 through 2023: 243 tree-care-related occupational fatalities in the United States.
TCIA's causes breakdown puts struck-by incidents first, at 93 of the 243, including 50 workers struck by trees and 35 by limbs.
Falls come next, at 50, including 26 from trees and 19 from aerial lifts.
Electrical contact accounts for 37 deaths, and it gets its own section below.
On the nonfatal side, BLS's Survey of Occupational Injuries and Illnesses put landscaping services (NAICS 56173) at 3.0 total recordable cases of injury or illness per 100 full-time workers in 2024, against 2.3 for all private industry.
OSHA's 2026 heat program lists NAICS 5617 (the sector above it) among its target industries, and notes that the sector includes landscaping services and tree removal and tree trimming services.
OSHA's tree-care hazards page also links NIOSH FACE investigation reports, including cases of palm tree workers suffocated by falling palm fronds in California.
Electrical hazards
Contact with energized power lines is on OSHA's list of common tree-care hazards, and TCIA's count for 2020 through 2023 includes 37 electrical-contact deaths.
That places electricity among the trade's leading named causes.
The trade's most specifically regulated corner is line clearance.
Under OSHA's 29 CFR 1910.269, line-clearance tree trimming means tree work within 10 feet of electric supply lines energized up to 50 kV to ground.
The required margin grows by 4 inches for each 10 kV above that.
That section spells out who may do the work.
A line-clearance tree trimmer is an employee familiar, through related training or on-the-job experience or both, with the special techniques and hazards of the work.
A trainee under direct supervision can perform duties they have shown they can do safely.
When a trimmer will approach closer than 10 feet to conductors energized above 750 volts, a second line-clearance trimmer must stay within normal voice communication.
The section also bans line-clearance work in adverse weather and requires storm-work trimmers to be trained in its special hazards.
The section applies to work done on behalf of the organization that operates or controls the lines; trimming for homeowners or other commercial entities is not covered by it.
In May 2025 OEWS data, 49,520 of the 55,160 wage-and-salary jobs for tree trimmers and pruners were in services to buildings and dwellings.
That sector includes landscaping and tree services companies.
The same OEWS count puts 1,040 tree trimmers and pruners on electric power utilities' payrolls.
That utility figure undercounts utility work, because utility line-clearance contractors are generally classified in services industries, not utilities.
The worker takeaway is to know which rules govern your crew's work near lines, and to ask how an employer handles jobs that bring a climb close to a conductor.
For the full breakdown of crew roles and the utility side of the trade, see our tree climber career guide.
How training and ANSI Z133 reduce risk
The regulatory picture is unusual for such a hazardous trade.
OSHA has no tree-care-specific standard: tree care must comply with the general industry standards in 29 CFR 1910, and OSHA notes that ANSI Z133, the tree-care safety standard, is voluntary.
OSHA has been weighing a dedicated Tree Care Operations rule for a long time.
An advance notice of proposed rulemaking was published on September 15, 2008, a stakeholder meeting followed on July 13, 2016, and a small-business review panel ran in April and May 2020.
The agency's rulemaking page still lists the next step as publishing a proposed rule.
The Z133 standard fills part of that gap.
The current edition is ANSI Z133-2026, Safety and Health Requirements for Arboricultural Operations, approved by ANSI; the previous edition, from 2017, was effective until 27 May 2026.
ISA offers the digital PDF free for individual use, with print copies at $29.95 retail or $24.95 for members.
BLS's occupational description gives the training floor: tree trimmers must use fall protection gear and wear hardhats and goggles for most activities.
Beyond that floor, the specifics come from an employer's program, from the standard itself and (for utility line clearance) from the training, trainee-supervision and storm-work requirements in 29 CFR 1910.269.
Standards change — verify the current edition and the current rules
Choosing a safe employer
Because OSHA treats Z133 as voluntary, the standard's force in practice comes from the companies that adopt it.
That makes an employer's safety program a legitimate thing to weigh when you compare job offers, and the questions worth asking map directly onto the fatality causes above.
- Does the company train and work to ANSI Z133-2026, the current edition of the arboriculture safety standard?
- Is fall protection gear provided and enforced, with hardhats and goggles as the baseline BLS describes for tree trimmers?
- How does the company handle trees near energized lines: decline the job, coordinate with the utility, or subcontract it to a line-clearance crew?
- Who does the aerial-lift work, and what training and supervision apply to it? Lift falls were 19 of TCIA's 50 fall deaths from 2020 through 2023.
- What training and supervision apply on storm and emergency call-outs, where crews meet storm-damaged trees?
TCIA's count keeps pointing to the same three causes: struck-by incidents, falls and electrical contact.
Questions about each one tell you more about a company than any generic safety pledge.
Career information, not legal, tax, insurance or safety advice. Fatality figures above are BLS's Census of Fatal Occupational Injuries and TCIA's own count, as cited. Confirm the rules that apply to your work with OSHA and with your employer's safety program before you rely on any of it.

